How to Unclog a Clogged Drain: A Step by Step Definitive Guide

Make your homemade drain opener. Does your house have clogged drains? You don’t have to resort to caustic soda or other corrosive products. Discover how to unclog pipes with a homemade trick that mixes hot water, vinegar, and baking soda.

One of the most common problems in a house is clogged drains, either by letting inappropriate elements pass into the drains (garbage, dressings, food remains, etc.) or because the pipes clog them over time. You can trash that accumulates during everyday use.

Although in most cases it is advisable to call a professional to solve the problem of clogged pipes, you should know that, as long as it is not a severe case, you can unclog the drains yourself.

To carry out this work, yes or yes, you need a pipe unclogging product that helps you “loosen” or disintegrate the materials causing the obstruction.

What Causes a Clogged Drain?

The most common causes of a clogged drain are tree roots, hair, grease, food particles, and paper towels. If the drain is backed up with discolored water or sewage, it is time for professional help. To clear a clogged drain yourself, try one of these tips:

• Use a plunger: Place the plunger over the drain and push and pull the handle in opposite directions several times to dislodge the blockage. If using a plunger on a standard sink drain, be sure to use caution not to cause damage by pulling too hard on the plunger handle.
• Pour a pot of boiling water down the drain: Pour a pot of boiling water down the drain and wait one minute. Use a plunger to suction onto the obstruction and pull up. Be careful not to pour too much hot water down the drain and cause a fire.
• Clear blockages with an auger: If using an auger (a long metal pole with a sharp end), insert it into the drain about two feet above the obstruction and turn it slowly until the obstruction is cleared. Be careful not to puncture your drains!

How to Unclog Heavily Clogged Drains

Preparing a homemade drain opener is not complicated, and here you will find two ideas—a completely natural one with vinegar, baking soda, and water at its boiling point. You can also use a homemade caustic soda drain opener, a slightly riskier recipe but very useful. Forget about your clogged drain with either of these two tricks to do at home.

Unclog Drain with Homemade Vinegar and Baking Soda

If you need to know how to unclog a clogged drain and are worried about not finding another way to clear that drain other than with caustic soda, then maybe it’s time to give this trick a try. I’ll tell you how to make a homemade drain opener.

To prepare this homemade drain opener, you will not need such abrasive chemicals; you will only need boiling water, bicarbonate, and vinegar. Do not hesitate to try this homemade drain opener.

Materials

• Half a cup of baking soda
• A cup of white vinegar
• Four liters of water to a boil

Preparation

• Place the baking soda inside the drain in question that you want to uncover (it does not work for the toilet).
• Add half the vinegar, and you will see that the mixture begins to do its job.
• Add the rest of the acid element and leave it to act for approximately 15 minutes.
• Dump the boiling water immediately and in one go.

The drain has been wholly uncovered without using any chemicals. Now you know how to prepare a natural homemade drain opener! It is even helpful if you are looking to discover a drain full of soil.

Unclog Drain with Homemade Baking Soda

The most used home remedy to unclog drains is, without a doubt, this one. Do you want to know how to unclog drain with baking soda? Remember that it is a somewhat dangerous ingredient that can cause chemical burns, so you should always wear rubber gloves and protect your eyes.

Materials

• 3.5 liters of cold water
• 3 cups caustic soda
• An old wooden spoon

Process

• Mix the water and the caustic soda in a bucket. Mix with an old wooden spoon, always with gloves and eye protection.
• You will notice that little by little, the mixture will begin to heat up.
• Pour into the drain and leave for half an hour.
• Then pour 2 liters of boiling water. Repeat if necessary.

How to Unclog a Patio Drain

If you are looking for how to unclog the patio drain, it is likely full of leaves and other organic waste that seeps into the drain, clogging it. In this case, proceed as follows, taking care to put on gloves before starting work:

• Remove all the water that is stuck.
• Next, remove any debris that is within reach of your hand.
• Help yourself with a thick wire to finish unclogging the drain.
• Pour in water to make sure it is already circulating normally.

You already know how to unclog a patio drain. The same procedure could be helpful if you need to know how to unclog a drain.

How to Unclog a Drain Using a Plunger

If you find yourself with a clogged drain, there are a few things you can do to try and fix it. One option is to use a plunger, which can unclog most drains quickly and easily. Here’s how to do it:

1. Find the clogged drain. It’s usually easiest to unclog a drain if you can find it right away. If the drain is in the corner of the room, for example, try squeezing around the side of the cabinet to see if anything loosens. If you can’t find it immediately, stick a dowel or piece of tubing down the drain and use it to help guide your plunger.

2. Place the plunger over the drain opening and push down firmly. Make sure that you keep your grip on the plunger handle so that you don’t accidentally pull it out of the drain.

3. Wait until the water has started flowing freely again before removing the plunger. If necessary, you can try using a second plunger in succession or use a plunger with a longer neck to get deeper into the clog. Remember to wait until the water flow has returned to normal before removing any debris from the drain!

How to Unclog a Drain Using a Vacuum Cleaner

If you’ve ever had a clogged drain, you know how frustrating it can be. And if you haven’t yet experienced clogged drains, you’re definitely in for a treat! Here’s how to unclog a drain using a vacuum cleaner:

1. Turn on the vacuum cleaner and set the power to low. Make sure the vacuum cleaner hose is extended all the way out from the machine.

2. Put the end of the hose into the drain and turn on the vacuum cleaner. When the machine starts up, it will create suction and try to pull the debris out of the drain. Keep turning the vacuum cleaner on and off until all of the debris has been removed.

3. If there are still clumps of debris in the drain, use a plunger to suction onto them and pull them out. Be careful not to dislodge any more pieces of debris that may have fallen into the drain while cleaning it up!